Pass the Cisco CCNP Security 300-715 Questions and answers with Dumpstech

A network engineer must create a guest portal for wireless guests on Cisco ISE. The guest users must not be able to create accounts; however, the portal should require a username and password to connect. Which portal type must be created in Cisco ISE to meet the requirements?

An administrator is responsible for configuring network access for a temporary network printer. The administrator must only use the printer MAC address 50:89:65: 18:8: AB for authentication. Which authentication method will accomplish the task?

An organization is adding nodes to their Cisco ISE deployment and has two nodes designated as primary and secondary PAN and MnT nodes. The organization also has four PSNs An administrator is adding two more PSNs to this deployment but is having problems adding one of them What is the problem?

An engineer needs to configure Cisco ISE Profiling Services to authorize network access for IP speakers that require access to the intercom system. This traffic needs to be identified if the ToS bit is set to 5 and the destination IP address is the intercom system. What must be configured to accomplish this goal?

A network security engineer needs to configure 802.1X port authentication to allow a single host to be authenticated for data and another single host to be authenticated for voice. Which command should the engineer run on the interface to accomplish this goal?

Which port does Cisco ISE use for native supplicant provisioning of a Windows laptop?

An engineer is configuring ISE for network device administration and has devices that support both protocols. What are two benefits of choosing TACACS+ over RADUs for these devices? (Choose two.)

An administrator is configuring a new profiling policy in Cisco ISE for a printer type that is missing from the profiler feed The logical profile Printers must be used in the authorization rule and the rule must be hit. What must be done to ensure that this configuration will be successful^

An administrator must provide wired network access to unidentified Cisco devices that fail 802.1X authentication. Cisco ISE profiling services must be configured to gather Cisco Discovery Protocol and LLDP endpoint information from a Cisco switch. These configurations were performed:

• configured switches to accept SNMP queries from Cisco ISE

• enabled Cisco Discovery Protocol and LLDP on the switches

• added the switch as a NAD to Cisco ISE

What must be enabled to complete the configuration?

Wireless network users authenticate to Cisco ISE using 802.1X through a Cisco Catalyst switch. An engineer must create an updated configuration to assign a security group tag to the user's traffic using inline tagging to prevent unauthenticated users from accessing a restricted server. The configurations were performed:

• configured Cisco ISE as a Cisco TrustSec AAA server

• configured the switch as a RADIUS device in Cisco ISE

• configured the wireless LAN controller as a TrustSec device in Cisco ISE

• created a security group tog for the wireless users

• created a certificate authentication profile

■ created an identity source sequence

• assigned an appropriate security group tag to the wireless users

• defined security group access control lists to specify an egress policy

• enforced the access control lists on the TrustSec policy matrix in Cisco ISE

• configured TrustSec on the switch

• configured TrustSec on the wireless LAN controller

Which two actions must be taken to complete the configuration? (Choose two.)