Pass the Huawei HCIP-Datacom H12-841_V1.5 Questions and answers with Dumpstech

In Huawei campus WLAN solutions, different WLAN architectures are designed to meet varying network scales, cost requirements, and management complexity. The architecture described in this question matches theLeader APsolution.

ALeader APcan operate independently without a dedicated wireless controller, while also having the capability to manage asmall number of subordinate APs. The Leader AP takes on lightweight control functions, such as basic configuration management and simple roaming coordination among the managed APs. This allows wireless users to roam between APs with minimal service interruption, meeting basic mobility requirements.

According to HCIP Datacom Campus Network documentation, the Leader AP architecture is characterized bylow deployment cost and simple maintenance. Since no separate AC is required and the number of APs is limited, network planning and configuration are straightforward. This significantly reduces the technical skill level required for daily operation and maintenance, making it suitable for small campuses, retail stores, branch offices, and small enterprises.

In contrast,Fat APsoperate completely independently and do not support centralized roaming management.AC + Fit AParchitectures are designed for medium to large networks and require higher investment and professional maintenance.Agile distributed APsolutions focus on centralized APs and RUs, which do not align with the independent AP management described.

Therefore, the WLAN architecture that best fits the given characteristics isLeader AP, making optionAthe correct answer.

iMaster NCE-CampusInsight is anintelligent O&M analysis componentin Huawei’s CloudCampus Solution, designed to provide deep visibility, experience assurance, and fault diagnosis based onreal service traffic and user behavior. The statement is incorrect because CampusInsight doesnot rely on SNMP technologyto achieve its core capabilities.

According to HCIP Datacom Campus Network documentation, traditional SNMP is mainly used for basic device monitoring, such as interface status, CPU usage, memory usage, and simple alarms. SNMP focuses ondevice-level metricsand does not provide sufficient granularity to analyze application performance, user experience, or end-to-end service paths.

In contrast, iMaster NCE-CampusInsight usestelemetry, traffic sampling, flow analysis, and packet-level inspection technologiesto collect real-time and fine-grained data directly from network devices. These technologies allow CampusInsight to analyzeactual service traffic, identify application behavior, locate faults across the network path, and proactively detect network exceptions that affect user experience.

CampusInsight correlates data such as flow information, latency, packet loss, and service reachability to perform intelligent analysis and root cause identification. This enables capabilities like application experience assurance, abnormal traffic detection, and proactive fault prediction, which are beyond the scope of SNMP-based monitoring.

Therefore, because iMaster NCE-CampusInsight does not use SNMP as its primary data collection method and instead relies on advanced telemetry and traffic analysis technologies, the statement isFALSE.

Comprehensive and Detailed 200 to 250 words of Explanation From HCIP Datacom Campus Network documents knowledge without any URL or Links:

In Huawei campus access authentication designs, network access is divided intopre-authentication,isolation, andpost-authenticationdomains to control user access at different stages of authentication.

Thepre-authentication domainprovides users with only the most basic network services required to initiate authentication. These services typically includeDHCPandDNS. DHCP allows unauthenticated terminals to obtain IP addresses and basic network parameters, while DNS enables domain name resolution so that users can reach authentication portals or admission servers. Therefore,DHCP and DNS servers are essential components of the pre-authentication domain, making optionsC and D correct.

AnFTP serveris a general-purpose file transfer service and is not required for user authentication. Anantivirus serverbelongs to theisolation domain, where users are redirected if authentication fails or if their devices do not meet security posture requirements, such as outdated virus signatures. These servers provide remediation resources but are not part of the pre-authentication process.

According to HCIP Datacom Campus Network documentation, limiting the pre-authentication domain to only essential services reduces security risks while ensuring successful user onboarding.

Comprehensive and Detailed Explanation (200–250 words):

In an iMaster NCE-Campus policy control matrix, rows representsource security groupsand columns representdestination security groups. A green check mark indicates that communication is allowed, while a red cross indicates that communication is denied. This matrix enables fine-grained user access control in VXLAN-based virtualized campus networks.

From the figure, communication betweenGuest_Group and Research_Groupis explicitly denied in both directions, as indicated by red crosses. Therefore, statementsAandDare both correct. The matrix also shows a green check mark forSales_Group communicating with itself, meaning intra-group communication is permitted, makingstatement B correct.

Theunknowngroup represents users that are not classified into Guest_Group, Research_Group, or Sales_Group. In the matrix, the unknown group is not completely blocked from all resources by default; access behavior depends on explicit policy configuration. Since the figure does not indicate a universal deny policy for unknown users toward all destinations,statement C is incorrect.

According to HCIP Datacom Campus Network policy control design, security group–based access control allows administrators to precisely define which user groups can communicate, improving security and service isolation. Hence, the correct answers areA, B, and D.

In a VXLAN-based campus or data center network, different node roles are defined to ensure proper traffic forwarding between traditional networks, the VXLAN overlay, and external networks. According to HCIP Datacom Campus Network documentation,edge nodes(also known as VTEPs) are responsible for encapsulating and decapsulating traffic between traditional Layer 2 or Layer 3 networks and the VXLAN overlay network. This allows legacy networks to communicate with virtualized VXLAN segments.

However, when traffic needs to leave the VXLAN fabric and accessexternal networks, such as a WAN, Internet, or another non-VXLAN domain, theborder nodeis used. The border node sits at the boundary of the VXLAN fabric and provides interconnection between the VXLAN network and external routing domains. It performs functions such as VXLAN termination, route advertisement, and traffic forwarding between overlay and underlay or external networks.

In BGP EVPN-based VXLAN deployments, the border node typically participates in BGP routing to exchange reachability information with external devices, ensuring seamless communication between VXLAN tenants and outside networks. This architectural separation improves scalability, simplifies network design, and enhances control over traffic entering or leaving the VXLAN fabric. Therefore, the correct node through which a VXLAN network accesses an external network is theBordernode.

In a VXLAN BGP EVPN network, different EVPN route types are used to advertise specific kinds of control-plane information.BGP EVPN Type 2 routes, also known asMAC/IP Advertisement routes, are primarily used to advertise Layer 2 and host-level Layer 3 reachability information between VTEPs.

According to HCIP Datacom Campus Network documentation, a Type 2 route carriesMAC address information, and it can optionally carry ahost IP addressassociated with that MAC. This enables efficient MAC learning and ARP suppression within the VXLAN fabric. TheL2VNIis also included in Type 2 routes, as it identifies the Layer 2 broadcast domain to which the MAC and IP information belongs.

TheL3VNIis not used to identify a Layer 2 broadcast domain but is associated with Layer 3 VPN forwarding and inter-VNI routing. While L3VNI information is relevant in EVPN-based Layer 3 services, it is not the primary identifier in a Type 2 route. However, the key distinction in this question lies in the difference between host routes and prefix routes.

AnIP prefixrepresents a network segment rather than a single host and is advertised usingEVPN Type 5 (IP Prefix) routes, not Type 2 routes. Type 2 routes only carry host IP addresses, not IP prefixes. Therefore,IP Prefixis not carried in a BGP EVPN Type 2 route, making optionCthe correct answer.

In campus network architecture, theegress zoneplays a critical role as the boundary between the internal campus network and external networks such as the Internet, WAN, or cloud services. According to HCIP Datacom Campus Network design principles, the egress zone must meet multiple functional and security requirements to ensure stable, secure, and flexible network operation.

First,network connectivityis a fundamental requirement. The egress zone must reliably connect the campus intranet to external networks, ensuring uninterrupted access to external resources and services. High availability and redundancy are often considered in this aspect to avoid single points of failure.

Second,network secure ensuranceis essential. As the main security boundary, the egress zone must protect the campus network from external threats. This typically involves deploying security mechanisms such as firewalls, intrusion prevention, traffic filtering, and attack defense to ensure data and service security.

Third, the egress zone must provide strongservice control capability. This includes traffic identification, policy-based forwarding, bandwidth management, and application control. These capabilities allow administrators to optimize service quality, prioritize critical applications, and manage user access to external services.

Finally,various and flexible access modesare required to support different external connection scenarios, such as Internet access, MPLS WAN access, VPN connections, and cloud interconnection. This flexibility enables the campus network to adapt to evolving business and service requirements.

Therefore, all listed options are essential requirements for proper egress zone design, makingA, B, C, and Dthe correct answers.

Comprehensive and Detailed 200 to 250 words of Explanation From HCIP Datacom Campus Network documents knowledge without any URL or Links:

In the Huawei CloudCampus Solution, devices such as switches and APs support multipleprovisioning modesto integrate with iMaster NCE-Campus, including Web interface provisioning, CLI-based provisioning, and registration center query. These methods allow devices to obtain controller information and register successfully.

Firewalls, however, have stricter provisioning mechanisms due to security considerations. They do not supportDHCP Option 148, which is commonly used by switches and APs to automatically discover the management controller.

Instead, firewalls must be provisioned manually through the Web interface or CLI, or discovered via registration center mechanisms. According to HCIP Datacom Campus Network documentation,DHCP Option 148 is not supported by firewalls, makingoption Cthe correct answer.

Comprehensive and Detailed 200 to 250 words of Explanation From HCIP Datacom Campus Network documents knowledge without any URL or Links:

Port isolation is commonly used on access switches to preventwired terminalsfrom communicating directly with each other at Layer 2. This enhances security by blocking lateral attacks and unnecessary broadcast traffic.

Forwireless users, Huawei APs and WLAN controllers (or central APs in agile distributed scenarios) providewireless user isolationmechanisms. Wireless user isolation prevents clients connected to the same SSID or AP from directly communicating with each other, even though they share the same wireless medium. This is widely used in guest networks, dormitories, and public WLAN environments.

Therefore, the statement that APs cannot implement wireless user isolation is incorrect. According to HCIP Datacom Campus Network WLAN design principles,wireless user isolation is fully supported by APs, either locally or under centralized control.

Hence, the statement is FALSE, and option B is correct.

Comprehensive and Detailed 200 to 250 words of Explanation From HCIP Datacom Campus Network documents knowledge without any URL or Links:

Dynamic VLAN authorization allows edge devices to dynamically assign users to specific VLANs based on authentication results. This mechanism is widely used to guide user traffic into the correct VN in a CloudCampus virtualized campus network.

Forwired users, bothMAC address authenticationand802.1X authenticationsupport dynamic VLAN assignment. Once authentication succeeds, the authentication server delivers authorization VLAN information to the edge node, and users are placed into the corresponding VLANs. Therefore, statementsCandDare correct.

Forwireless users,802.1X authenticationalso supports dynamic VLAN authorization, making statementBcorrect. However,Portal authentication for wireless users does not support dynamic VLAN assignmentin CloudCampus networks. Wireless Portal authentication typically controls access rights rather than VLAN placement.

According to HCIP Datacom Campus Network documentation, statement A is false, making it the correct answer.