Pass the Cisco CCNP Enterprise 300-430 Questions and answers with Dumpstech

When a client is authenticated but cannot pass traffic in the RUN state, it indicates that an ACL may be blocking the traffic post-authentication. Disabling or modifying this ACL to allow traffic can resolve the connectivity issue, ensuring that the client’s traffic flows correctly after authentication with Cisco ISE.

 The exhibit provided appears to be a floor map overlay with Cisco CleanAir Zone of Impact for interferers, which shows different areas affected by interference on a wireless network. The area labeled ‘A’ indicates the greatest impact on the wireless network due to its larger size compared with other zones, suggesting more significant interference or a stronger source of interference within this zone. References := ( CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide )

 FlexConnect is a wireless solution for branch office and remote office deployments. It allows APs to switch data traffic locally and perform client authentication locally when their connection to the controller is interrupted. For the scenario described, where a corporation is spread across different countries and wants to minimize delays while ensuring strong connectivity, FlexConnect with central switching enabled is appropriate. This configuration allows traffic to be switched locally at the AP, reducing the amount of traffic traversing the MPLS network to the central WLC, thus minimizing delays. References := CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide

To rename access points and add them to the correct AP groups on a wireless controller, the minimum custom attributes required using Cisco ISE TACACS is role1=WIRELESS. This role provides the necessary permissions for read/write access to wireless-related configurations. References := (CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide)

 To prevent honeypot attacks most efficiently, the wireless network engineer should set the auto containment level to 4 and select the Using Our SSID containment option (D). This configuration allows the system to automatically contain rogue APs that are spoofing the organization’s SSID, which is a common tactic in honeypot attacks. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide.

A Public-Signed SAN (Subject Alternative Name) certificate allows multiple domain names to be protected with a single certificate. This is useful in a distributed environment like a guest portal on Cisco ISE, where there may be multiple nodes with different Common Names (CNs). Using a SAN certificate can prevent CN mismatch errors during SSL/TLS handshakes. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide

The correct command to add a VLAN with a specific ID to a FlexConnect group in a Cisco Wireless LAN Controller (WLC) is ‘config flexconnect group BranchA-FCG vlan 30 add’. This command specifies the FlexConnect group name ‘BranchA-FCG’ and the VLAN ID ‘30’, followed by the action ‘add’, which is consistent with Cisco’s CLI syntax for WLC configuration. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide