Spring Sale Limited Time 75% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = simple75
Pass the Cisco CCNP Data Center 350-601 Questions and answers with Dumpstech
Which feature of Cisco Nexus Dashboard permits users to switch between site controllers of Cisco ACI?

Refer to the exhibit. The PowerShell script uses cmdlet to create the MAC pool resource on the Cisco UCS Manager. Which command resolves the issue?
A Cisco UCS C-Series server needs to be installed in a data center. The server must be managed by using Cisco UCS Manager with a single cable for management and data traffic. Which set of commands must be run on the server after a physical connection is established?
A)

B)

C)

D)

Which configuration must be used to boot a Cisco UCS C-Series Server using iSCSI?
A network engineer must configure a power redundancy policy on a Cisco UCS C-Series Rack Server. The power redundancy must support two power sources being used to power the server. Which configuration should be applied to meet the requirement?


Refer to the exhibit A Cisco VXLAN fabric must detect when a VM with an IP address of 11.0.0.100 moves between servers The engineer must also unfreeze the endpoint Which command accomplishes this goal?
An engineer must configure Protocol Independent Multicast on two Cisco Nexus 9000 Series Switches. The engineer must ensure that the chosen rendezvous point (RP) uses a mapping agent and only supports one RP per multicast group. Which type of RP must be used on both switches to meet these requirements?

Refer to the exhibit. The network management system that is located at 192.168.10.10 and port 2000 must receive traps from the Cisco UCS Manager called UCSM. The community name is Cisco123! and the SNMP version must be the most secure.
These two commands have already been configured on Cisco UCSM.
UCS-A# scope monitoring
UCS-A/monitoring # enable snmp
Which command set completes the SNMP configu

Which component is upgraded by using an EPLD upgrade on a Cisco Nexus 9000 Series Switch?
In a data center based on Cisco Nexus 9000 Series Switches, all endpoints support explicit congestion notifications How does the Nexus switch respond when the ECN-enabled queue reaches the maximum WRED threshold?