Black Friday VIP Hour Limited Time 75% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = simple75

Pass the HP Aruba Certified Switching Expert HPE7-A08 Questions and answers with Dumpstech

Exam HPE7-A08 Premium Access

View all detail and faqs for the HPE7-A08 exam

Practice at least 50% of the questions to maximize your chances of passing.
Viewing page 5 out of 5 pages
Viewing questions 41-50 out of questions
Questions # 41:

Based on the images provided , which CLI command was used to produce this output?

Question # 41

Options:

A.

Use checkpoint diff to compare running-config with stored checkpoints.

B.

Use show checkpoint compare to compare running-config with stored saved-config revisions.

C.

Use show checkpoint diff to compare running-config with stored checkpoints.

D.

Use checkpoint compare to compare running-config with stored saved-config revisions.

Questions # 42:

Refer to the exhibit:

Question # 42

Using the configuration below, you have configured OSPF at a small branch site, which only requires a single default route to reach the Internet and all other sites. When examining the routing table, you still see other OSPF routes besides the default route.

What OSPF area type should you configure?

Options:

A.

Totally Not-So-Stubby Area

B.

Stub Area

C.

Totally Stubby Area

D.

Not-So-Stubby Area

Questions # 43:

A Linux SFTP server is configured for IP address 192.168.1.100, and the CX 6325 switch has a management IP address 192.168.1.200.

How can you back up the saved switch configuration to a remote location?

Options:

A.

Use the command copy startup-config scp://user@192.168.1.100/switch_config.cfg vrf default on the switch.

B.

Use the command scp admin@192.168.1.200:/running-config on the SFTP server.

C.

Use the command copy startup-config sftp://user@192.168.1.100/switch_config.cfg vrf mgmt on the switch.

D.

Use the command scp admin@192.168.1.200:/startup-config on the SFTP server.

Questions # 44:

How would you describe the firmware upgrade process for an HPE Aruba Networking VSX cluster?

Options:

A.

After the upgrade, the vsx-syned process can resume synchronization even if the switches are in a different firmware version

B.

After the upgrade, the vsx-syned process will continue synchronization, once vsx-upgrade commit is issued

C.

During the upgrade, the vsx-syned process will stop synchronization while the software versions are mismatched

D.

During the upgrade, the vsx-syned process will continue synchronization while the software versions are mismatched

Questions # 45:

Refer to the exhibit:

Question # 45

The interface is configured on an HPE Aruba Networking CX 8320 for a VMware server NIC, and the server admin reports that VMware vMotion traffic on VLAN 3903 fails, but the server can ping other ports with default settings.

What must be done to correct the issue based on the provided interface status and configuration?

Options:

A.

Configure jumbo on VLAN 3903

B.

Configure jumbo on interface 1/1/36

C.

Configure MTU 9198 on interface 1/1/36

D.

Configure MTU 9198 on VLAN 3903

Questions # 46:

You need to configure BGP on an HPE Aruba Networking switch using AS 65010. What is required when establishing peering with neighboring devices using eBGP AS 65100?

Options:

A.

Use of peer AS 65001

B.

Use of route-reflector

C.

Use of directory connected peer

D.

Use of address-family ipv4 internal

Questions # 47:

Your customer’s CISO would like to deploy colorless ports across the network. Which will you need to configure to meet this requirement?

Options:

A.

Active gateway

B.

Downloadable User Roles

C.

Virtual active forwarding

D.

Downloadable fingerprints

Questions # 48:

For the aggregation layer, you must configure two new HPE Aruba Networking CX 6200M (VSF) switches. LACP link aggregations to downstream access switches using redundant ports from both switches are required.

Which configuration example would create the required lag setup on both switches utilizing HPE Aruba Networking clustering and stacking technologies?

Question # 48

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Questions # 49:

A database administrator has reported intermittent connectivity issues with a SQL server hosted in the data center and has provided you with the source and destination IP addresses. Which troubleshooting methodology would be the most suitable to start with?

Options:

A.

Spot the difference

B.

Follow the path

C.

Divide and conquer

D.

Top-down/Bottom-up

Questions # 50:

What does it mean when an event like the one below is seen on the HPE Aruba Networking CX switch?

2024-04-04T08:35:38.312254+00:00 ICX-Core-1 hpe-vaxd[2167]: Event[701|LOG_INFO|AMM1/1|VSX2 state local up, remote down]

Options:

A.

VSX secondary switch is down.

B.

VSX keepalive has detected that the secondary member is down.

C.

The multichassis LAG 2 interface is down on both switches.

D.

The physical interface of LAG 2 on the secondary VSX member is down.

Viewing page 5 out of 5 pages
Viewing questions 41-50 out of questions