Spring Sale Limited Time 75% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = simple75

Pass the Cisco CCNP Enterprise 300-410 Questions and answers with Dumpstech

Exam 300-410 Premium Access

View all detail and faqs for the 300-410 exam

Go to Exam

Practice at least 50% of the questions to maximize your chances of passing.

Viewing page 12 out of 13 pages

Viewing questions 166-180 out of questions

Questions # 166:

Which statement about IPv6 RA Guard is true?

Options:

It does not offer protection in environments where IPv6 traffic is tunneled.

It cannot be configured on a switch port interface in the ingress direction.

Packets that are dropped by IPv6 RA Guard cannot be spanned.

It is not supported in hardware when TCAM is programmed.

Questions # 167:

Refer to the exhibits.

Question # 167

Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN. Which two

commands are missing? (Choose two.)

Options:

The ip nhrp redirect command is missing on the spoke routers.

The ip nhrp shortcut command is missing on the spoke routers.

The ip nhrp redirect commands is missing on the hub router.

The ip nhrp shortcut commands is missing on the hub router.

The ip nhrp map command is missing on the hub router.

Questions # 168:

Which two statements about redistributing EIGRP into OSPF are true? (Choose two)

Options:

The redistributed EIGRP routes appear as type 3 LSAs in the OSPF database

The redistributed EIGRP routes appear as type 5 LSAs in the OSPF database

The administrative distance of the redistributed routes is 170

The redistributed EIGRP routes appear as OSPF external type 1

The redistributed EIGRP routes as placed into an OSPF area whose area ID matches the EIGRPautonomous system number

The redistributed EIGRP routes appear as OSPF external type 2 routes in the routing table

Questions # 169:

What is a prerequisite for configuring BFD?

Options:

Jumbo frame support must be configured on the router that is using BFD.

All routers in the path between two BFD endpoints must have BFD enabled.

Cisco Express Forwarding must be enabled on all participating BFD endpoints.

To use BFD with BGP, the timers 3 9 command must first be configured in the BGP routing process.

Questions # 170:

An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?

Options:

sudo maglev-config update

sudo maglev install config update

sudo maglev reinstall

sudo update config install

Questions # 171:

An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table. What should be configured to accomplish this task?

Options:

set ip next-hop

set ip default next-hop

set ip next-hop recursive

set ip next-hop verify-availability

Questions # 172:

Which statement about MPLS LDP router ID is true?

Options:

If not configured, the operational physical interface is chosen as the router ID even if a loopback is configured.

The loopback with the highest IP address is selected as the router ID.

The MPLS LDP router ID must match the IGP router ID.

The force keyword changes the router ID to the specified address without causing any impact.

Questions # 173:

Refer to the exhibit.

Question # 173

A network engineer for AS64512 must remove the inbound and outbound traffic from link A during maintenance without closing the BGP session so that there ............ a backup link over link A toward the ASN. Which BGP configuration on R1 accomplishes this goal?

Question # 173

Options:

Option A

Option B

Option C

Option D

Questions # 174:

Refer to the exhibit.

Question # 174

Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?

Question # 174

Options:

Option A

Option B

Option C

Option D

Questions # 175:

Refer to the exhibit.

Question # 175

ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to

achieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?

Options:

Start-time 00:00

Start-time 0

Start-time immediately

Start-time now

Questions # 176:

Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right.

Question # 176

Options:

Questions # 177:

Refer to the exhibit.

Question # 177

The network administrator configured VRF lite for customer A. The technician at the remote site misconfigured VRF on the router. Which configuration will resolve connectivity for both sites of customer_a?

Question # 177

Options:

Option A

Option B

Option C

Option D

Questions # 178:

Refer to the exhibit.

Question # 178

The output of the trace route from R5 shows a loop in the network. Which configuration

prevents this loop?

Question # 178

Options:

Option A

Option B

Option C

Option D

Questions # 179:

An engineer configured a leak-map command to summarize EIGRP routes and advertise specifically loopback 0 with an IP of 10.1.1.1.255.255.255.252 along with the summary route. After finishing configuration, the customer complained not receiving summary route with specific loopback address. Which two configurations will fix it? (Choose two.)

Question # 179

Options:

Configure access-list 1 permit 10.1.1.0.0.0.0.3.

Configure access-list 1 permit 10.1.1.1.0.0.0.252.

Configure access-list 1 and match under route-map Leak-Route.

Configure route-map Leak-Route permit 10 and match access-list 1.

Configure route-map Leak-Route permit 20.

Questions # 180:

Refer the exhibit.

Question # 180

Which action resolves intermittent connectivity observed with the SNMP trap

packets?

Options:

Decrease the committed burst Size of the mgmt class map

Increase the CIR of the mgmt class map

Add a new class map to match TCP traffic

Add one new entry in the ACL 120 to permit the UDP port 161

Viewing page 12 out of 13 pages

Viewing questions 166-180 out of questions