Pass the Cisco CCNA 200-301 Questions and answers with Dumpstech

Which protocol uses the SSL?

Refer to the exhibit.

Routers R1 and R3 have the default configuration The router R2 priority is set to 99 Which commands on R3 configure it as the DR in the 10.0 4.0/24 network?

Which two spanning-tree states are bypassed on an interface running PortFast? (Choose two.)

What is an expected outcome when network management automation is deployed?

Refer to the exhibit.

Traffic that is flowing over interface TenGigabitEthernet0/0 experiences slow transfer speeds. What is the reason for the issue?

Which Layer 2 switch function encapsulates packets for different VLANs so that the packets traverse the same port and maintain traffic separation between the VLANs?

Refer to the exhibit.

Packets received by the router from BGP enter via a serial interface at 209.165.201.10. Each route is present within the routing table. Which interface is used to forward traffic with a destination IP of 10.10.10.24?

Refer to the exhibit.

Which two commands when used together create port channel 10? (Choose two.)

Refer to the exhibit.

Which configuration enables DHCP addressing for hosts connected to interface FastEthernetO/1 on router R4?

A Cisco engineer is configuring a factory-default router with these three passwords:

• The user EXEC password for console access is p4ssw0rd1

• The user EXEC password for Telnet access is s3cr3t2

• The password for privileged EXEC mode is pnv4t3p4ss Which command sequence must the engineer configured

A)

B)

C)

D)

Which QoS per-hop behavior changes the value of the ToS field in the IPv4 packet header?

A network administrator is setting up a new IPv6 network using the 64-bit address 2001 0EB8 00C1 2200:0001 0000 0000 0331/64 To simplify the configuration the administrator has decided to compress the address Which IP address must the administrator configure?

Which type of network attack overwhelms the target server by sending multiple packets to a port until the half-open TCP resources of the target are exhausted?

Refer to the exhibit.

Which command must be issued to enable a floating static default route on router A?

Refer to the exhibit.

Which next-hop IP address does Routed use for packets destined to host 10 10.13.158?

Refer to the exhibit.

Web traffic is coming in from the WAN interface. Which route takes precedence when the router is processing traffic destined for the LAN network at 10 0.10.0/24?

A network engineer must configure two new subnets using the address block 10 70 128 0/19 to meet these requirements:

• The first subnet must support 24 hosts

• The second subnet must support 472 hosts

• Both subnets must use the longest subnet mask possible from the address block

Which two configurations must be used to configure the new subnets and meet a requirement to use the first available address in each subnet for the router interfaces? (Choose two )

Refer to the exhibit.

Users on existing VLAN 100 can reach sites on the Internet. Which action must the administrator take to establish connectivity to the Internet for users in VLAN 200?

Refer to the exhibit.

All VLANs are present in the VLAN database. Which command sequence must be applied to complete the configuration?

An engineer is tasked to configure a switch with port security to ensure devices that forward unicasts multicasts and broadcasts are unable to flood the port The port must be configured to permit only two random MAC addresses at a time Drag and drop the required configuration commands from the left onto the sequence on the right Not all commands are used.

Refer to the exhibit.

An engineer is asked to insert the new VLAN into the existing trunk without modifying anything previously configured Which command accomplishes this task?

Which type of IPv6 address is similar to a unicast address but is assigned to multiple devices on the same network at the same time?

Drag and drop the descriptions of AAA services from the left onto the corresponding services on the right.

Refer to the exhibit.

A static route must be configured on R14 to forward traffic for the 172 21 34 0/25 network that resides on R86 Which command must be used to fulfill the request?

A Cisco engineer must configure a single switch interface to meet these requirements

• accept untagged frames and place them in VLAN 20

• accept tagged frames in VLAN 30 when CDP detects a Cisco IP phone

Which command set must the engineer apply?

A)

B)

C)

D)

Refer to the exhibit.

Router R1 currently is configured to use R3 as the primary route to the Internet, and the route uses the default administrative distance settings. A network engineer must configure R1 so that it uses R2 as a backup, but only if R3 goes down. Which command must the engineer configure on R1 so that it correctly uses R2 as a backup route, without changing the administrative distance configuration on the link to R3?

Refer to the exhibit.

An engineer is configuring a new router on the network and applied this configuration. Which additional configuration allows the PC to obtain its IP address from a DHCP server?

What is the function of the controller in a software-defined network?

Which characteristic differentiates the concept of authentication from authorization and accounting?

What is the difference between IPv6 unicast and anycast addressing?

Which WLC management connection type is vulnerable to man-in-the-middle attacks?

Drag and drop the threat-mitigation techniques from the left onto the types of threat or attack they mitigate on the right.

Which field within the access-request packet is encrypted by RADIUS?

Refer to the exhibit.

Site A was recently connected to site B over a new single-mode fiber path. Users at site A report Intermittent connectivity Issues with applications hosted at site B. What is the reason for the problem?

Refer to the exhibit.

The following must be considered:

• SW1 is fully configured for all traffic

• The SW4 and SW9 links to SW1 have been configured

• The SW4 interface Gi0/1 and Gi0/0 on SW9 have been configured

• The remaining switches have had all VLANs adde d to their VLAN database

Which configuration establishes a successful ping from PC2 to PC7 without interruption to traffic flow between other PCs?

A)

B)

C)

D)

Refer to the exhibit.

A network engineer must update the configuration on Switch2 so that it sends LLDP packets every minute and the information sent via LLDP is refreshed every 3 minutes Which configuration must the engineer apply?

A)

B)

C)

D)

Refer to the exhibit.

An engineer built a new L2 LACP EtherChannel between SW1 and SW2 and executed these show commands to verify the work. Which additional task allows the two switches to establish an LACP port channel?

Refer to the exhibit.

An engineer is configuring an EtherChannel using LACP between Switches 1 and 2 Which configuration must be applied so that only Switch 1 sends LACP initiation packets?

Refer to the exhibit.

How should the configuration be updated to allow PC1 and PC2 access to the Internet?

Refer to the exhibit.

The link between PC1 and the switch is up. but it is performing poorly. Which interface condition is causing the performance problem?

Refer to the exhibit.

Host A sent a data frame destined for host D

What does the switch do when it receives the frame from host A?

Refer to the exhibit.

An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?

A)

B)

C)

D)

What are two benefits of FHRPs? (Choose two.)

Refer to the exhibit.

Packets received by the router from BGP enter via a serial interface at 209 165 201 1 Each route is present within the routing table Which interface is used to forward traffic with a destination IP of 10.1.1.19?

Which PoE mode enables powered-device detection and guarantees power when the device is detected?

An engineer is configuring remote access to a router from IP subnet 10.139.58.0/28. The domain name, crypto keys, and SSH have been configured. Which configuration enables the traffic on the destination router?

A)

B)

C)

D)

Which value is the unique identifier that an access point uses to establish and maintain wireless connectivity to wireless network devices?

How does Rapid PVST+ create a fast loop-free network topology?

Drag and drop the characteristics of networking from the left onto the networking types on the right.

Refer to the exhibit.

All traffic enters the CPE router from interface Serial0/3 with an IP address of 192 168 50 1 Web traffic from the WAN is destined for a LAN network where servers are load-balanced An IP packet with a destination address of the HTTP virtual IP of 192 1681 250 must be forwarded Which routing table entry does the router use?