Pass the Cisco CCNP Service Provider 350-501 Questions and answers with Dumpstech

Refer to the exhibit. A regional company is implementing a network-health monitoring solution on their Cisco ISR routers to monitor network performance metrics and gather real-time data. The router R1 Ethernet interface, GigabitEthernet0/0, is assigned IP address 192.168.1.1/24, and basic IP addressing and connectivity to the data-collection server have already been configured. A network engineer must update R1 to ensure secure and reliable data transmission to the monitoring server, which is located at IP address 192.168.50.50 on port 50051. To achieve secure communication, the configuration must comply with RFC 5246, and to ensure reliable data transmission, it must follow RFC 793. Which command must the engineer execute to configure data collection?

Which protocol is used for communication between the PCE and PCC?

Refer to the exhibit. Customer C-101 in ASN 65123 requested that the ISP blackholes a host route 198.19.44.195, to which the customer is receiving a significant amount of malicious traffic. Which configuration must the network engineer implement on the trigger router TR-1 to fulfill the request without affecting other IP destinations in the customer's block?

Refer to the exhibit. A growing company with an increasing international presence requires a secure and scalable solution for inter-office data transfer across their geographically dispersed locations. To ensure departmental privacy, the network must enforce granular access control. BGP is running in the network, and two VRF instances with unique route distinguishers and route targets have been configured to segregate critical financial data from regular network traffic. A network engineer with an employee ID: 5086:72:617 must find a solution that allows for future network expansion while maintaining robust security and data privacy between departments. The solution must comply with the RFC 4364 standard. Which action must the engineer take to meet the requirements?

What are the four primary components of an API?

Drag and drop the LDP features from the left onto their usages on the right.

Refer to the exhibit.

The customer that owns the CE-1, CE-2, and CE-3 routers purchased point-to-point E-Line services from the Carrier Ethernet provider. The service provider is delivering multiplexed UNI at the customer HQ location on PE-1 and untagged UNIs at the PE-2 and PE-3 locations. Additionally, the customer provided these VLAN to EVC mapping requirements:

• EVC 1 between CE-1 and CE-2 must be provisioned with C-VLAN 12 at the HQ location.

• EVC 2 between CE-1 and CE-3 must be provisioned with C-VLAN 13 at the HQ location.

Which configuration must the network engineer implement on the PE routers to provide end-to-end Carrier Ethernet service to the customer?

What are two characteristics of MPLS TE turrets? (Choose two)

Refer to the exhibit.

Router R1 is reporting that its BGP neighbor adjacency to router R2 is down, but its state is Active as shown. Which configuration must be applied to routers R1 and R2 to fix the problem?

A)

B)

C)

D)

A company uses PIM-SM multicast with IGMPv2 to stream training videos from a server in one network to hosts in a different network. As the company has grown, the networking team decided to implement SSM to improve efficiency for multicast within Layer 2. Which action must the team take to begin the process?

A router is advertising multiple networks to its BGP neighbor in AS 5200 with peer IP address 1.1.1.1. Which configuration must be applied so that the router permits updates only for networks with a prefix mask length less than or equal to 21?

Refer to the exhibit.

R101 is peering with R102 and R103, and R201 is peering with R202 and R203 using iBGP Labeled Unicast address families. The OSPF area 0 border routers are in a full iBGP Labeled Unicast mesh, and VPNv4 routes are exchanged directly between PE routers R101 and R201 through iBGP Which address family-level configuration must be applied on ABR R102 on ABR R102 to support a Unified MPLS routing architecture with partitioned IGP domains?

A)

B)

C)

D)

A network operator working for a private outsourcing company with an employee id: 4261:72:778 needs to limit the malicious traffic on their network. Which configuration must the engineer use to implement URPF loose mode on the GigabitEthernet0/1 interface?

Refer to the exhibit:

An engineer is preparing to implement data plane security configuration.

Which statement about this configuration is true?

How is a telemetry session established for data analytics?