Summer Sale Limited Time 75% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code = simple75

Pass the Cisco CCNP Collaboration 350-801 Questions and answers with Dumpstech

Exam 350-801 Premium Access

View all detail and faqs for the 350-801 exam

Go to Exam
Practice at least 50% of the questions to maximize your chances of passing.
Viewing page 12 out of 13 pages
Viewing questions 111-120 out of questions
Questions # 111:

A customer reports that the load balancing solution is not working (or two Cisco Unified Border Element routers. The (cube1.abc.com) router should take 60% of the calls, and the (cube2 abc.com) router should take 40% of the calls. Assuming all DNS A records are present, which two SRV configurations would provide the desired outcome? (Choose two.)

Question # 111

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

E.

Option E

Questions # 112:

An engineer with troubleshoots poor voice quality on multiple calls. After looking at packet captures, the engineer notices high levels of jitter. Which two areas does the engineer check to prevent jitter? (Choose two.)

Options:

A.

Voice packets are classified and marked

B.

All devices use wired connections instead of wireless connections

C.

The network meets bandwidth requirements

D.

Cisco UBE manages voice traffic, not data traffic

E.

MTP is enable on the sip trunk to cisco Unified Border Elemnet

Questions # 113:

An engineer must configure switch port 5/1 to send CDP packets to configure an attached Cisco IP phone to trust tagged traffic on it’s access port. Which command is required to complete the configuration?

Question # 113

Options:

A.

platform qos trust extend cos 3

B.

platform qos trust extend

C.

platform qos extend trust

D.

platform qos trust extend cos 5

Questions # 114:

Question # 114

Refer to the exhibit. A collaboration engineer adds a redundant NTP server to an existing Cisco Collaboration solution On the Cisco UCM OS Administration page, the new NTP server shows as "Not Accessible" Which action resolves this issue?

Options:

A.

Restart NTPD on the Cisco UCM server.

B.

Delete and re-add the new NTP server via the Cisco UCM command-line interface

C.

Start the NTP service on the new NTP server

D.

Configure the "reach" value as "377" for the new NTP server.

Questions # 115:

Refer to the exhibit.

Question # 115

An engineer verifies the configured of an MGCP gateway. The commands are already configured. Which command is necessary to enable MGCP?

Options:

A.

Device(config)# mgcp enable

B.

Device(config)# ccm-manager enable

C.

Device (config) # com-manager active

D.

Device (config)# mgcp

Questions # 116:

Which DiffServ value must be used to identify and classify audio and video from Cisco Telepresence endpoints according to the Cisco dual video queue approach?

Options:

A.

AF42

B.

CS3

C.

CS4

D.

AF41

Questions # 117:

Which value should be changed when each Cisco UCM node does not allow for more than 5000 phones to be registered?

Options:

A.

Maximum Number of Registered and Unregistered Devices service parameter on each node

B.

Minimum Number of Phones service parameter on each node

C.

Maximum Number of Registered Devices service parameter on each node

D.

Maximum Number of Phones service parameter on the Publisher

Questions # 118:

Which SNMP service must be active manually after Cisco UCM is installed?

Options:

A.

Connection SNMP Agent

B.

Host Resources Agent

C.

SNMP Master Agent

D.

Cisco CallManager SNMP

Questions # 119:

For Webex Calling, how are outbound transfers and forwards restricted for a particular call type?

Options:

A.

together on an organization-by-organization basis

B.

together on a site-by-site basis

C.

independently on an organization-by-organization basis

D.

independently on a site-by-site basis

Questions # 120:

How many dial patterns can a Webex Calling dial plan support?

Options:

A.

1,000

B.

2,000

C.

10,000

D.

12,000

Viewing page 12 out of 13 pages
Viewing questions 111-120 out of questions